CONNECTIX Reader Firmware Recovery Tool
Use this tool when an Identix CONNECTIX reader no longer boots, is stuck in a reboot loop, or cannot be updated through the normal update path. The tool writes the recovery bootloader over USB. You then install the CONNECTIX firmware through the reader’s own Wi-Fi page.
You need: a computer with Google Chrome or Microsoft Edge, a USB data cable (charge-only cables do not show a port), a screwdriver to open the reader, and a computer or phone with Wi-Fi for step 4.
This browser cannot talk to USB serial ports. Open this page in Google Chrome orMicrosoft Edge on a Windows, macOS or Linux computer.
1 Firmware files
Loading firmware files…
2 Connect the reader
- Disconnect all power from the reader: power supply, PoE/Ethernet and USB.
- Open the case and find the BOOT button on the main board (not RST).
- Hold BOOT, connect the USB cable to this computer, wait one second and release BOOT.
- Click Connect and pick the port named USB JTAG/serial debug unit.
3 Write the recovery bootloader
The tool writes the recovery image at address 0x0. It takes about a minute. Do not unplug the USB cable while it runs. Writing this image resets the reader's settings (network, MQTT and reader configuration), so you will configure the reader again afterwards.
Advanced
4 Install the CONNECTIX firmware over Wi-Fi
- Download the firmware now, while this computer still has internet:Download firmware
- The tool restarts the reader after writing, so you can leave the USB cable connected. If the network in the next step does not appear within about 30 seconds, unplug the USB cable and plug it back inwithout pressing BOOT.
- After a few seconds the reader creates a Wi-Fi network named
Identix-BL XX:XX:XX. Connect to it with password. Stay connected even if the computer warns there is no internet. - Open
http://192.168.4.1in the browser (typehttp://, nothttps://). - Choose the file you downloaded above (
) and click Upload Firmware. - Wait for the Upload Successful! message. The reader restarts into CONNECTIX and the
Identix-BLnetwork disappears.
Upload the connectix_…_ota.bin file only on this Wi-Fi page. The bootloader image is written only over USB in step 3.
Technical log
For the full procedure, including how to do it without this tool, see How to Flash the Bootloader and CONNECTIX firmware.
Troubleshooting
Section titled “Troubleshooting”- No port appears when you click Connect: try another USB cable or USB port, and repeat step 2 holding BOOT before you plug in the cable. Close any other program that uses the port (serial monitor, IDE, ESP Flash Download Tool).
- The
Identix-BLnetwork does not appear after step 3: make sure BOOT is not pressed when you power the reader up. Repeat steps 2 and 3. - The upload fails with “OTA write failed” or “File size must be less than 3MB”: you selected the wrong file. Use the
connectix_…_ota.binfile from step 4. - The page at 192.168.4.1 does not open: check that you are connected to the
Identix-BLnetwork, turn off any VPN, and typehttp://explicitly. - The reader still does not work after recovery: repeat step 3 with Advanced › Erase the whole flash checked, then step 4.
The tool uses esptool-js by Espressif Systems, licensed under the Apache License 2.0.