Skip to content

How to put Identix RFID readers in Bootloader Mode

This article describes two supported procedures to place the DR-mini and DR-pad readers into bootloader mode for firmware programming. In bootloader mode, the device enumerates a COM (JTAG) port suitable for flashing tools.

Applies to: DR-mini, DR-pad Audience: Field technicians, manufacturing, support engineers

  • Magnet safety: Strong neodymium magnets can affect magnetic cards, watches, and medical implants. Keep a safe distance from sensitive items and from people with pacemakers.
  • ESD: If the unit is open, observe ESD precautions before touching the PCB.
  • Power: Always disconnect USB power before starting either procedure.
  • Data: Bootloader entry interrupts normal operation. Save logs or data before you proceed.

Use this method when the unit is closed or sealed.

You need a small neodymium magnet.

  1. Disconnect the reader from the USB port.
  2. Place the magnet on the indicated spot on the enclosure. The location is marked on the device label or mechanical drawing. Keep the magnet in place.
  3. Reconnect the reader to the USB port while the magnet is still in position.
  4. Result: The reader enters bootloader mode and mounts a COM (JTAG) port for programming. Once the COM (JTAG) port is visible on your system, you can remove the magnet.

Notes and tips

  • If the COM (JTAG) port does not appear within 5 to 10 seconds, remove power, reposition the magnet precisely over the indicated area, and repeat.
  • USB hubs can delay enumeration. If you have problems, connect directly to a host USB port.

Use this method when the device is open and you have access to the main PCB.

You need access to the main board and the BOOT tact switch.

  1. Disconnect the reader from the USB port.
  2. Press and hold the BOOT button.
  3. Reconnect the reader to the USB port while holding BOOT.
  4. Result: The reader enters bootloader mode and mounts a COM (JTAG) port for programming. You can release the BOOT button after the COM (JTAG) port appears.

Notes and tips

  • If the COM (JTAG) port does not appear, repeat the sequence and make sure BOOT is held before and during power-on.
  • Confirm you are pressing the BOOT key, not RST (reset).
  • Open Device Manager, then Ports (COM & LPT), and confirm a newly listed COM device associated with JTAG or the bootloader.
  • Your flashing tool should now be able to connect to this COM (JTAG) interface.

Unplug USB power and reconnect it without the magnet (Option A) or without holding BOOT (Option B). The device starts in normal application mode.

  • No COM port appears: Try a different USB cable or port, and avoid low-power hubs. Repeat the sequence carefully, since timing matters.
  • Magnet in the wrong place: Make sure the magnet is exactly on the marked location. A few millimeters off can prevent detection.
  • Security or driver prompts: Install any drivers your programming environment requires if the operating system asks for them.
  • Still not working: Power-cycle the reader and try the PCB method (Option B) to rule out magnet placement.