Identifying the Connectors on Identix RF Cables
Every Identix antenna cable has a connector on each end. Before you order a cable or connect an antenna to a reader, check that the two ends mate. The guide below shows each connector in drawings, cutaways and 3D views, and lists the ends of every Identix RF cable.
Connector guide (PDF, 15 pages) Cable table only (PDF, 1 page)Three questions to identify a connector
Section titled “Three questions to identify a connector”- How big is the thread? It tells you the family: about 6 mm (1/4″) is SMA, about 11 mm (7/16″) is TNC, about 16 mm (5/8″) is N.
- Is the thread inside or outside? A nut that turns, threaded on the inside, is male. A body threaded on the outside is female.
- Pin or socket in the center? Standard connectors have a pin on the male and a socket on the female. Reverse polarity (RP) swaps them: socket on the male, pin on the female.
Ports on Identix equipment
Section titled “Ports on Identix equipment”- SMA female: every Identix antenna, the DR-mini, DR-max, EM300 and EM300H readers, and the SAMDK-300/500/700 boards.
- RP-TNC female: the EZ500 and EZ700 readers.
- No Identix reader or antenna has an RP-SMA or N port. The cables with an N male end are for third-party equipment.
Reading the part number
Section titled “Reading the part number”In Identix RF cable part numbers, the code names the ends: TMR = RP-TNC male, TFR = RP-TNC female, SM or SMA = SMA male, NM = N male. The suffix gives the length: XS (1.2 to 1.5 m), S (3 m), L (4 m), XL (8 m). For example, ID-TMR-SM-S is a 3 m cable with an RP-TNC male end and an SMA male end, the cable that connects an EZ500 or EZ700 reader to an Identix antenna.